Page 1 of 1

Want to remove VPC3

PostPosted: February 20th, 2015, 3:02 pm
by sunshine
Hi every one, I recently purchased a Charger with VPC3, it has 3 pulleys. Don't know if it's a Charger 1 or 2? I would like to know if anyone knows the set-up to remove VPC. I find the kite moves to fast for me. I tried it for the first time on snow and could not keep it steady to put my board on. I am use to older twin skin, this one is powerful and fast. Can I just attach to the pig tails on the ends of spars and forget about the middle loop? I found set-ups on the net but they are all difficult to understand. What is the best set-up. My name is Alain.

Re: Want to remove VPC3

PostPosted: February 23rd, 2015, 4:26 pm
by aatamian
Hi Alain,

Yes, I guess you can remove the VPC with no problem, done this on my Synergy 10m for high winds.
The steering radius becomes much bigger!
All the best.
Avo

Re: Want to remove VPC3

PostPosted: April 8th, 2015, 12:05 pm
by Hardwater Kiter
The VPC can be removed. 3 Pulleys = Charger 1.

You can disassemble the VPC and install pigtails like you would find on a non-VPC Arc. The pigtail specs will depend on the size of the kite.

The bar pressure will increase and the turn rate will be slower. But if you muscle it you can still make it fly snappy.

Re: Want to remove VPC3

PostPosted: November 13th, 2017, 6:27 pm
by joudot
aatamian wrote:Hi Alain,

Yes, I guess you can remove the VPC with no problem, done this on my Synergy 10m for high winds.
The steering radius becomes much bigger!
All the best.
Avo


Hi what are the length of pigtails on L.E and T.E
for Synergy 10 m ?